Carrying Strap; Operation; Removing/Inserting Battery Pack; Setting The Direction Of Rotation, Engag- Ing The Transporting Safety Device (Switch-On Lock) - Metabo BHA 18 Mode D'emploi

17026813_0907 BHA 18 NAFTA.book Seite 8 Dienstag, 9. Oktober 2007 1:20 13
ENGLISH
ENG
6.2

Carrying strap

If necessary, hang the hook on the Metabo
carrying strap (10) on the eyelet (8). Set the
carrying strap (10) to the desired length.
Carrying:
To prevent unintentional start-up, move
the rotation selector switch (7) to
centre position (transporting safety
device).
Never carry with a tool inserted.
The machine must only be carried with
the Metabo carrying strap (10) across
chest and back (illustration a, page 3).
Hold the machine steady.
The machine must NOT be carried with
the carrying strap (10) around your neck
(illustration b, page 3).

7 Operation

Charge the battery pack before use.
The battery pack reaches its full capacity only
after being charged and discharged 5 times
(charge cycles).
The maximum number of charge cycles can
only reached if an exhaustive discharge of the
battery pack is avoided. If performance dimin-
ishes, recharge the battery pack.
Store NiMH battery packs when charged and
recharge after 6 months at the latest.
Li-Ion battery packs (18 V)
have a capacity and signal display:
- Press the button and the charge level is
displayed by the LEDs.
- If one LED is flashing, the battery pack is
almost flat and must be recharged.
- If all LEDs are flashing, the electronic system
has switched off the battery pack (self-
protection mode).The battery pack is either
flat (the electronic system protects the
battery pack against exhaustive discharge),
or has become overloaded or too warm
during operation (temperature monitoring).
To continue using the battery pack: Press
the button or insert the battery pack into the
charger, which is ready for use. (Rapid
cooling is possible in the "AIR COOLED"
battery charger.)
8
7.1

Removing/inserting battery pack

Removing battery pack:
Press battery pack release button (9) and take out
battery pack (11).
Inserting:
Insert battery pack (11) until it engages.
7.2 Setting the direction of rotation, engag-
ing the transporting safety device
(switch-on lock)
Do not activate rotation selector switch
(7) unless the motor has completely
stopped!
Actuate the rotational direction switch (direction of
rotation setting, transporting safety device).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Middle position: transportation safety
device (Switch-on lock) set
7.3

Switching On and Off

To start the machine, press the trigger switch (6).
The speed can be changed using the trigger
switch.
7.4

Operating mode selection

Select the desired operating mode by turning the
switch button (4). To turn, push in the lock (5).
Drilling
Hammer drilling
Avoid levering with the machine when a
drill bit is fitted.
7.5

Tool change with SDS chuck

Before fitting, clean tool shank and
apply special grease (accessories order
no. 6.31800)!
Use only SDS-Plus tools.
Inserting the tool:
Turn the tool while inserting until it locks into
place. The tool is automatically locked.