Charging The Battery - Würth ERGOPOWER DUAL Traduction Du Mode D'emploi Original

• Damage or inappropriate use of the battery:
— may lead to the emission of vapours that irritate
the respiratory tract. Supply fresh air and consult
a doctor if you have medical complaints.
— may cause liquids to leak from the battery.
Avoid contact with the liquid. Leaking battery
with water after accidental contact. Consult
a doctor as well if liquid gets into the eyes.
— may lead to an internal short-circuit that causes
the battery to overheat and explode or burst
— A damaged device or charger may no longer
be used and may only be exchanged by the
manufacturer.
GB
Operation
(1) Carrying handle
(2) Light output
(3) Base with:
(a) holes for wall attachment
(b) hole for stand attachment
(4) Connection of mains power supply
(
100 – 240 V~) via
in the delivery
(5) USB connection type A; for connecting a
USB consumer
(6)
(7) Display battery charging level in percent
(8) Connection of vehicle charger (8.4 V=)
included in delivery
8
mains cable included

Charging the battery

Only charge the battery with the mains cable or
vehicle charger included in the delivery:
1. Remove the protective cap from the connector (4)
or (8) and connect the cable or charger.
2. Connect the mains cable to the mains socket
(100 – 240 V~) or the charger to Connector (8)
and the 12 V or 24 V on-board network socket.
The "100 %" indicator lights up when the battery
is fully charged. Do not charge the battery
longer than required to prevent overheating.
3. Disconnect the mains cable or the charger and
attach the protective cap for Connector (4) or (8).
Notes regarding operation
The switched-on lamp is very bright and the lamp
may get hot in the vicinity of the light outlet. When
the lamp is switched on:
• do not look directly into the light outlet.
• ensure that nobody is exposed to glare.
• do not cover the light outlet.
• do not put down the lamp with the light outlet
pointing downwards.