Sony DDM-2801CU Mode D'emploi page 13

1 DEGAUSS switch
This switch demagnetizes the screen. Momentarily
press this switch with the power turned on. Wait for 5
minutes or more before activating the switch again.
2 H STAT control
This control adjusts the convergence at the center of
the screen, so that the vertical red and blue lines
converge with the green line.
R G B
(Chassis model)
Move red line to the
(B/C model)
right, and blue line to
the left
3 V STAT control
This control adjusts the convergence at the center of
the screen, so that the horizontal red and blue lines
converge with the green line.
B
(Chassis model)
G
R
(B/C model)
Move red line
upward, and blue line
downward
4 V CENT control
This control adjusts the vertical position of the picture.
(Chassis model)
Move the picture
(B/C model)
upward
5 BRIGHT control
B G R
6 CONT control
Move red line to the
left,and blue line to
the right
7 Power indicator
R
G
8 POWER switch
B
Move red line
downward, and
blue line upward
Move the picture
downward
This control adjusts the picture brightness. Normally set
the control at the center detent position.
(Chassis model)
For a brighter
picture
(B/C model)
This control adjusts the picture contrast.
For more contrast (Chassis model)
(B/C model)
This indicator lights when the POWER switch is turned
on.
When the MAIN circuit breaker on the rear panel is
turned on, press the POWER switch to turn on the
display. At this time, automatic degaussing will be
activated causing the picture to shake for about 5
seconds. To turn off the display, press the POWER
switch again.
For a darker
picture
For less contrast
13