fortress S-Serie Manuel D'utilisation page 34

9.10 cHArGer SAFety FeAtUreS:
The charger has features that prevent hazards or
accidents occurring as a result of connecting batteries
the wrong way round, overheating caused by fault
conditions or attempting to charge wrong voltage
batteries.
WArNING!
• Always replace fuses with the same type and size of
fuse as specified.
• Fitting of different fuses can result in damage to the
charger or failure of the charger to operate properly.
• If your charger has been specified for use in Canada,
it will contain a CSA approved three prong grounded
plug which does not have a fuse.
9.11 ProceDUre For coNNectING tHe cHArGer
AND cHArGING:
The scooter can be charged via the charger socket on
the rear of the tiller panel. FIG.9.2
• Ensure the scooter is switched off.
• First, connect the charger to the scooter.
• Then, connect the charger to the mains supply by
means of the mains plug and switch on.
• The RED LED will illuminate to show that the power
is ON, (FIG.9.3).
• The RED LED flashes to show a fault.
• The YELLOW LED will illuminate to show the
batteries are charging, (FIG.9.3).
• The YELLOW LED flashes to show incorrect or no
battery connected.
• The GREEN LED will illuminate when the charge
cycle is complete, (FIG.9.3).
cAUtIoN!
• Do not leave the charger connected to the battery
with the mains disconnected or switched off. This
could result in damage to your battery being caused
by deep discharge over a period of time.
• Always switch off at the mains before disconnecting
the charger from the scooter.
WArNING!
• If the RED LED flashes, switch the charger off at
the mains supply and contact your Sunrise Medical
authorized dealer.
34 Fortress S-Series
9.12 cHArGer SAFety AND cAUtIoN NoteS:
WArNING!
• The charger is designed for indoor use. Do not use
outdoors or expose to rain, snow, spray or moisture.
• When buying replacement batteries or charger always
consult your Sunrise Medical service agent.
• To reduce the risk of damage to electric plug and
cord, pull by the plug rather than the cord when
disconnecting the charger.
• Make sure the cord is located so that it will not be
stepped on, tripped over or otherwise subjected to
damage or stress or cause a trip hazard.
• A mains extension cord should not be used unless
absolutely necessary.
• Use of an improper extension cord could result in a
risk of fire and electric shock.
• If any extension cord must be used, make sure the
pins on the plug of the extension cord are the same
number, size and shape as those of the plug on the
charger and that the extension cord is properly wired
and in good electrical condition.
Note: The scooter can remain safely on charge for a
couple of weeks. When the scooter is not to be used for
a long period of time, first charge the batteries fully and
then disconnect them from the scooter. Store as close to
room temperature as is possible.
FIG.9.2
FIG.9.3