KEENCUT Big Bench Instructions De Montage page 6

3.2
4. Put grub screws in each of
the two large holes of the
bracket, only screw them in
2 or 3 turns.
Stage 2
1. Fit the two short beams between
each pair of leg assemblies
ensuring the small groove in the
beam is uppermost.
2. Pulling the two legs
together (to close
any gaps between
the end of the beam
and the legs) tighten
all the grub screws.
Stage 3
1. Place one end frame on the floor with the
brackets pointing upwards and position
a long beam over each bracket (again
ensure the small groove in the beam will
be uppermost).
2. Place either:
the other end frame (if you are
constructing a 1.0m or 1.5m
big bench)
or
The centre frame (if you are constructing
a 2.0m, 2.5m or 3.0m Big bench)
over the beams and tighten the grub screws
ensuring there are no gaps between the beam
ends and the legs.
3. 2.0m, 2.5m or 3.0m
Big bench only
Stand the frame onto its feet
and position the remaining
long beams between the
frame and the remaining end
frame, tighten all the grub
screws again ensuring there
are no gaps between the
beam ends and the legs.
Assembly
5. Fix the height adjusters into
the bottom of each leg.
Position the adjuster in one of
the internal grooves of the leg
(ie. the same groove the
brackets are fitted).
Position the bottom
of the aluminium
bracket level with
the bottom of the
leg and tighten the
grub screw fully.
TOP
TOP
3.2