Inserting The Bobbin - Singer 3221 Manuel D'instruction

Inserting the Bobbin

EN
When inserting or removing the bobbin, the needle must
be fully raised.
- Remove the extension table, then open the hinged cover.
(1)
- Pull the bobbin case tab (a) and remove the bobbin case. (2)
- Hold the bobbin case with one hand. Insert the bobbin so
that the thread runs in a clockwise direction (arrow). (3)
- Pull the thread through the slit and under the finger. (4)
Leave a 6 inch tail of thread.
- Hold the bobbin case by the hinged latch. (5)
- Insert it into the shuttle. (6)
Attention:
Turn power switch to off ("O") before inserting or
removing the bobbin.
1
3
6
13
a
2
5
4