Replacing The Led Lights - Errebi DAKAR EASY Notice D'utilisation

4.6 REPLACING THE LED LIGHTS

This operation is done as follows:
1) Turn the machine off using the general switch and disconnect the power
supply cable
2) Loosen the "Tracer adjustment locking screw" (9) and unscrew the "Tracer
height adjustment wheel" (8) until it is removed.
3) Unscrew the four screws (21) that secure the "Machine head guard" and
remove it. The screws are located on the front and back of the machine.
4) At the connection terminals, remove the two LED strap wires, noting the
previous position of each wire.
NOTE: To facilitate the understanding of step 1) to 4), see the figure in sec-
tion 4.3 (Tightening and replacing the belt).
5) Remove the cutter (F) and tracer (P) from their corresponding tool supports.
6) Remove the "Tracer movement spring lever" (7).
7) Unscrew the three screws (27) that fasten the burr protector (W) to the
machine head and remove it.
8) Detach the LED strap (L) and remove it.
9) To set up the new LED strap, perform the same operations in reverse order.
See figure 17
5 SAFETY
5
For safety reasons, we recommend following these guidelines:
• Do not attempt to start or handle the machine until all issues regarding sa-
fety, installation instructions, operating guides and maintenance procedures
have been fulfilled and understood.
• Always disconnect the power supply before performing any cleaning or
maintenance work.
• Always keep the machine clean, as well as its surrounding environment.
• Work with dry hands.
• Always use protective glasses even though the machine has protective
elements.
• Ensure that the machine is earthed.
We recommend working with the machine at a height where the user is com-
fortable:
• The highly recommended option is to work sitting down. Adjust the height
of the seat until the eyes of the user are at the same height as the highest
point of the machine.
• If standing to work, depending on the height of the user, it is recommended
that you place a support between the table and the machine, such that the
eyes of the user are at the same height as the highest point of the machine.
6
REMOVAL OF WASTE
Waste is understood to be any substance or object that derives from
human activities or natural cycles.
6.1 PACKAGING
As the packaging in which the DAKAR EASY is supplied is cardboard,
it can be recycled as packaging.
As waste, and considered solid urban waste, it can only be placed in
special containers for the recycling of cardboard.
The casing that protects the machine within the cardboard box is made
of polymer material comparable to solid urban waste. It cannot be eliminated
in any other way than through normal waste removal facilities.
16
DAKAR EASY instruction manual
6.2 BURRS
The waste produced in the duplication of keys is classified as special
waste, but it is classified as solid urban waste, for example, a metal scouring
pad. This waste will be removed according to the classification of current
legislation in the EU, being delivered to special waste removal facilities.
6.3 MACHINE
Before destroying the machine, it must be out of service, which is done
by cutting the electric supply source and separating the plastic pieces from
the metal pieces.
After doing this, all the waste may be eliminated in accordance with the
current legislation in the country where the machine is being used
7
EXPLODED PLAN
See figure 18
8 KEY-CUTTER-TRACER- ADAPTOR TABLE
REFERENCE
BRAND
CUTTER
TRACER
ADAPTOR