Mounting And Connecting; Installation Site; Unpacking; Ventilation - Dometic B29G Instructions De Montage Et De Service

Wine Refrigerators
6

Mounting and connecting

WARNING!
Instructions pertaining to the risk of death or serious injury!
• Move and set up the appliance by at least two people.
NOTICE!
Instructions pertaining to the risk of material damage!
• Do not place the appliance in direct sunlight or in the vicinity of strong heat sources (heating appliances, ovens,
etc.).
• Only locate the appliance indoors, never outside.
• Check that the voltage specification on the type plate is the same as that of the power supply.

6.1 Installation site

When selecting the location, observe the following instructions:
• The appliance should stand in the coldest part of the room, away from heat sources (ovens, heating devices or radiators).
• The location must not be damp or wet.
• The appliance must not be exposed to direct sunlight. This can damage the acrylic coating and lead to higher power con-
sumption.
• The ground must be level and sufficiently stable to bear the appliance at full capacity.
• The appliance must be sufficiently ventilated. The ventilation slots on the front of the appliance must not be obstructed.
• Observe the installation dimensions, see technical data.

6.2 Unpacking

1. Remove all the inner and outer packaging materials before setting up.

6.3 Ventilation

NOTICE!
• Ensure that the ventilation slots remain clear during the installation.
Obstructed ventilation slots lead to increased power consumption and can damage the appliance.
• Note that model E7FG needs at least 30 mm space on the rear side for ventilation (fig.

6.4 Adjusting the feet

1. Make sure the appliance is level by adjusting the feet (fig.

6.5 Reversing the door

You can change the hinge of the door, so that it opens to the left rather than the right. For reversing the door follow the steps in
the mentioned figures:
• Reversing the door at E18FGB and E49FGB (fig.
• Reversing the door at B29G and B68G (fig.
• Reversing the door at E7FG, E16FG, E28FG, E45FG, C20G and C50G (fig.
• Reversing the door at B162S, B195S, C101G, C125G, E91FG, E115FG (fig.

6.6 Mounting the door handle

Mount the door handle on the side opposite to the hinge. To get access to the bores partly lift off the sealing at the inside of the
door (fig. , on page 5).
EN
, on page 5).
, on page 7 to fig. , on page 7)
, on page 8 to fig. , on page 8)
4445103123
Mounting and connecting
, on page 5).
, on page 9 to fig. , on page 9)
, on page 10 to fig. , on page 11)
17