stayer BHL112BK Instructions D'emploi page 19

4_OPERATION
Starting Operation
Inserting the Battery
Use only original Stayer lithium ion batteries with
the voltage listed on the nameplate of your power
tool. Using other batteries can lead to injuries and
pose a fire hazard.
Not aply to 202-204 models:
Set the rotational direction switch 7 to the centre
position in order to avoid unintentional starting. Insert
the charged battery 5 into the handle so that it can be
felt to engage and faces flush against the handle.
Reversing the Rotational Direction
The rotational direction switch 7 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 8 actuated.
Right Rotation: For drilling and driving in screws, push
the rotati onal direction switch 7 left to the stop.
Setting the Torque / Setting the Operating Mode
The required torque can be preselected in 16 steps
with the torque preselection ring 3. With the correct
setting, the insert tool is stopped as soon as the screw
is screwed flush into the material or when the set
torque is reached.
Select a higher setting when driving out screws, or set
to the symbol "Drilling".
Drilling
Set the preselection ring 3 to the "Drilling without
impact" symbol.
The safety clutch is deactivated in the "Drilling"
position.
Impact drilling
P P
" " (PBL0000 K - BL000
Set the preselection ring 3 to the "Impact drilling"
symbol.
In the "Impact drilling" position, the safety clutch
is deactivated and the maximum power is always
effective.
Gear Selection, Mechanical
Actuate the gear selector 4 only when the machine
is at a standstill.
Two speed ranges can be preselected with the gear
selector 4.
Gear I:
Low speed range; for screwdriving or working with
large drilling diameter.
High speed range; for working with small drilling
diameter.
If the gear selector 4 cannot be fully engaged, lightly
rotate the drive spindle with the drill bit by twisting the
drill chuck.
Switching On and Off
To start the machine, press the On/Off switch 8 and
keep it pressed.
The light 6 is lit when the On/Off switch 8 is slightly
or completely pressed in and permits to light the work
area when the lighting conditions are bad.
To switch off the machine, release the On/Off switch 8
Start In / Out PBL202BL / PBL204BL
- Keep the tool in a natural way, with the index finger
on the touch panel forward 7 and the middle finger in
the reverse touch panel 8.
- Lightly press the buttons simultaneously tactile 7- 8.
Both LED work light and remaining power indicator will
illuminate for a few seconds.
- Release your fingers forward reverse pads 7 and 8.
The last 5 min tool enters a sleep mode, to disable it
you must push two soft buttons 7- 8 and thus ready
for use.
- The buttons are pressure sensitive in accordance
with the pressure rate 7 or 8 must be set within the
tool.
Run-on Brake
When the Touch pad 7 or 8 for PBL202 & 204 is
released, the chuck brakes to a stop, thus preventing
the run-on of the tool.
When driving in screws, wait until the screw is screwed
in flush with the material and then release the Touch
pad 7 or 8 for PBL202 & 204. By doing so, the head of
the screw does not penetrate into the material.
P
K)
- 19
Gear II:
LED
Lighting green
Lighting yellow
Lighting red
-
es
it
gb
de
fr
p
tr
gr
cz
Capacity
> 60%
30-60%
< 30%