Installation instructions:
Electrical system for towing hitch
Important notes
Read the installation manual prior to starting work.
The electrical kit should only be installed by qualified personnel.
Caution – Disconnect the battery!
Danger of damage to the vehicle's electronic system. Data which are stored
electronically may get lost.
Read out the fault storage prior to starting work.
Use a closed-circuit current conservation unit if necessary.
Make sure prior to drilling that no objects such as cables, for example, are located behind the
covers.
Deburr any bare body parts, like bore holes, and seal them with the help of some rust inhibitor.
Note
During installation, special attention has to be paid to the following points:
•
Cables may not be pinched or damaged.
•
All sealing elements have to be installed properly.
•
The socket gasket has to be positioned on the insulating sleeve and not on the individual
wires.
•
Lay the cables such that they do not rub on the vehicle and are not bent.
•
Do not lay any cables near the exhaust system.
•
Install the controller so that it is protected against the intrusion of moisture. The cable
connection should always face downward.
In the case of trailers without rear fog lamps, a rear fog lamp has to be retrofitted.
When a direction indicator lamp fails, also on the trailer, this is indicated by a higher flashing
frequency. No additional direction indicator check is necessary.
Use a corresponding adapter to adapt the system to a 7-pin trailer socket.
The adapter is available in specialist shops under the Westfalia part no. 300 130 300 113,
Fiat No. 59 11 506.
An electrical socket adapter may only be used in conjunction with a trailer. Remove the socket
adapter when the trailer is not in use.
Correct trailer operation has to be checked using a trailer or a test instrument with load resistors.
Subject to technical changes!
Fiat Fiorino
WESTFALIA Automotive GmbH
306 580 391 103 - 001 - 39/07
15