Function And Location Of The Controls - Midland Alan 78Plus Multi B Guide D'utilisation

FUNCTION AND LOCATION OF THE CONTROLS

1 2
88
FM SCAN
ALAN 78 PLUS CH
AM
MULTI LOW
9
5
3
1
0.5 1 2 3
LOCK EMG
EMG Q.UP Q.DOWN AM/FM
CHANNEL
3 4 5
1. Channel selector
2. Multifunction backlighted display. It shows:
88
A
B
1
0.5
LOCK EMG
I F
A. Channel selected number
B. The received signal strength and the power of the transmitting
signal
C. AM/FM mode
2
8 9
SQUELCH ON/OFF VOL
SIG
RX
+30
TX
4 PWR
SCAN
LCR
ON/OFF
6 7
C H E
CH FM
SCAN
AM LOW
SIG
+30 RX
9
5
3
TX
1 2 3 4 PWR
D. RX/TX:TX=transmit mode; RX=receive mode
SCAN mode
E.
F. EMG mode
G. Frequency band selected.
H. LOW: displayed when the radio transmits in low power (this
10
mode is possible with some frequency bands only – see the
Frequency band chart).
I. LOCK: microphone (UP/DOWN buttons) lock enabled.
3. "EMG" button: Emergency channel. By pressing it, you will be auto-
matically positioned on CH 9 (emergency channel). The display will
show "EMG". It will not be possibile to change accidentally the chan-
nel.
4. 5. "Q.UP/Q.DOWN" buttons: To skip 10 channels UP (Q. UP) or 10 chan-
MIC
nels DOWN (Q.DOWN).
6. "AM/FM"(LCR) button: To select AM or FM mode. If you switch on the
unit and push "AM/FM"(LCR) and "SCAN" at the same time, you will
select the operating band, which will be visualised on the display.
If you select a frequency band operating in FM mode only, this button
enables the LCR function (Last Channel Recall).
7. "SCAN" button: With this control, you can automatically seek for a
busy channel.
Turn the Squelch clockwise until the background noise is no longer
heard.
Press the "SCAN" button: the transceiver will scan automatically all the
G
channels.
If you switch on the unit and push "SCAN" and "AM/FM"(LCR) at the
D
same time, you will select the operating band, which will be visualised
on the display.
8. "Squelch" Control: For the maximum receiver sensitivity, the control
must be regulated exactly where the receiver background noise
disappears.
9. "ON/OFF Volume" Control. In "OFF" position your transceiver is OFF.
Turn this control clockwise to switch on the unit. Turn the knob
clockwise a little more to set the audio level, until you get a comforta-
ble reception.
10. Microphone jack: Insert the mic connector into this jack.