Pack Contents - Buffalo CW306 Mode D'emploi

• This appliance is not
intended for use by persons
(including children) with
reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge,
unless they have been given
supervision or instruction
concerning the use of the
appliance by a person
responsible for their safety.
• Children should be
supervised to ensure that
they do not play with the
appliance.
• Keep all packaging away
from children. Dispose of
the packaging in accordance
to the regulations of local
authorities.
• If the power cord is
damaged, it must be
replaced by an BUFFALO
agent or a recommended
qualified technician in order
to avoid a hazard.
• BUFFALO recommend that
this appliance should be
periodically tested (at least
annually) by a Competent
Person. Testing should
include, but not be limited
to: Visual Inspection, Polarity
CW306_ML_A5_v5_20210218.indb 3 CW306_ML_A5_v5_20210218.indb 3
Test, Earth Continuity,
Insulation Continuity and
Functional Testing.
• BUFFALO recommend that
this product is connected
to a circuit protected by an
appropriate RCD (Residual
Current Device).
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your BUFFALO product.

Pack Contents

The following is included:
• BUFFALO Filter Coffee Maker
• Filter basket
• 2.3Ltr Airpot
• Instruction manual
BUFFALO prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your BUFFALO dealer immediately.
Installation
• The appliance is not suitable for installation in
an area where a water jet could be used.
• Do not place the coffee maker on a highly
polished wooden surface as damage may occur
to the surface.
1. Connect the inlet hose supplied to the
appliance and the mains water supply.
2. Ensure the water pressure of the connected
water supply is between 20~90 PSI.
3. The use of a stop cock is recommended to
isolate the unit from the water supply for
servicing.
UK
3
2021/2/18 16:24 2021/2/18 16:24