How To Wire - Kenwood DRV-410 Mode D'emploi

How to Wire

Power cord for Dashboard Camera (accessory)
CAUTION
Dashboard Camera
Ignition key switch
Main fuse
Battery
10
Before performing the connection work, first check that the engine key
is removed and then be sure to disconnect the negative terminal of the
battery to prevent a short accident.
Connect the Dashboard Camera and power cord.
Fuse
Accessory power supply
ACC
BATT
Ground cord (Black)
Connect to a metal part of the vehicle (part of the chassis with an electrical
GND connection to the negative side of the power supply).
Accessory cord (Red)
Connect to a power supply that can
be turned on and off with the switch.
Battery cord (Yellow)
Connect to a power supply with a voltage always applied
regardless of whether or not the engine key is on or off at
a point after the power has passed through the main fuse.
Cord length (3.5 m)
Fuse (2 A)