Satin Stitch Appliqué; 3-Step Zigzag - ELNA eXcellence 720 Mode D'emploi

Satin Stitch Appliqué
The zigzag stitch is commonly used for appliqué,
monogramming, stems of flowers and petals. (A
short zigzag stitch length creates the satin stitch.)
Threads of 100% cotton, rayon or silk provide the
best results.
• Apply stabilizer to the fabric for the stitch to form
correctly.
Select 2.
Attach satin stitch foot F.
Decrease stitch width to 3.5 and stitch length to
0.40.
Appliqué Preparation
1. Press fusible webbing to the wrong side of a
lightweight fabric.
2. Cut out design shape. Fuse design to main fabric.
3. Sew design to fabric with the needle swinging off
the appliqué.
4. When you reach a place where you need to turn,
lower the needle into the fabric at the outer edge of
the turn. Raise the presser foot, turn fabric, lower
the presser foot and continue sewing. (You may
need to set the foot pressure dial to 2.)

3-Step Zigzag

The 3-step zigzag (sometimes called a multiple
zigzag) is used to finish raw seam edges on
synthetics and other fabrics that tend to pucker.
This stitch gives a flatter edge finish than the
regular zigzag and is excellent for darning and
mending tears in fabric.
Select 3.
Place the fabric under the presser foot so the
needle swings off the fabric to the right or trim
away any excess fabric.
78