Tip 6: Parallel supply lines may generate buzzing interference in the test lead. If the external interference
is too great, switch off the household power supply during measurement if possible.
Tip 7: TV sockets in particular may contain filters that have a negative effect on measurements. In this
case, remove the TV socket and perform the measurement directly at the cable.
7
Headphones
The headphones supplied enable you to analyse the receiver signals more accurately. IMPORTANT: Set the
volume control as low as it will go before connecting the headphones to the receiver (17) and putting
them on. An excessively high volume in the headphones may damage your hearing.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Remove the battery(ies) before storing for longer periods. Store the device in a clean and dry place.
Technical data
(Technical revisions reserved. 05.17)
Transmitter TX
Max. input voltage
Max. output current
Max. signal voltage
Max. testing length
Power supply
Dimensions (W x H x D)
Weight (incl. battery)
Receiver RECV
Max. input voltage
Max. output current
SCAN mode measuring range
Power supply
Dimensions (W x H x D)
Weight (incl. battery)
Transmitter TX / Receiver RECV
Operating conditions
Storage conditions
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at:
http://laserliner.com/info?an=mucache
MultiCable-Checker
20V DC
10 mA
8 Vss (peak-to-peak)
3 km
1 x 9V block, IEC LR6, Alkali
49 x 127 x 34 mm
130 g
20V DC
30 mA
0 ... 5 cm measuring depth
1 x 9V block, IEC LR6, Alkali
39 x 187 x 30 mm
135 g
0°C ... 50°C, Max. humidity 80% rH,
no condensation, max. altitude 2000 m
-10°C ... 60°C, Max. humidity 80% rH
11
EN