General Instructions - T&S Wok Wand B-0575 Instructions D'installation Et D'entretien

General Instructions

Installation:
1. Shut off water supply and drain lines. Existing supply lines should be
roughed into wall or sink back-splash. Use inlets (male for B-0575, female for
B-0576) supplied by others.
2. Install no.1 to supply line, using teflon tape. Flat side of no.1 should screw in
toward wall or sink.
supply
pipe
wall or
back-splash
3. Properly installed unit will function as shown below:
On-Off control actuated when nozzle swings to right or left.
position
position
closed
fully open
position
closed
Note: For cold water
use only
top view