Operation; Operation Safety Zone; Angle Adjustment Of Accessory; Troubleshooting - Texas COMBI 800 Manuel D'utilisation

Operation

Read the instruction manual for the engine,
before use.
Before using the machine, remove all foreign objects
from the vicinity. Stones, glass, branches and similar
items can damage the machine. Also check that all
bolts are tightened.
Control oil level before starting the engine.
See attached guide
Start the engine:
1. Open the fuel tap.
2. On a cold engine open the choker.
Note: By a hot engine choke is not required.
3. Turn the throttle cable to "start" position.
4. Pull the recoil starter gently until you feel
resistance in the rope. Then pull quickly and
energetic. Do not at any time let go of the
recoil starter but glide it gently back and pull
again.
5. Regulate the choker until the engine is running
smoothly.
Stop the engine:
1. Set the throttle to minimum gas.
2. Turn the fuel tap to the"off" position.
Clutch Lever A - Forward and Reverse.
To operate the black clutch lever A in Fig. 6, the
control stick must first be activated. By tilting the
control stick to the right or left side and then activate
the black handle, the machine will move forward or
backwards. To change direction release the lever and
enterthe desired gear postion.
Clutch Lever B - Activation of accessory.
To operate the black brush lever B in Fig. 6, the control
stick must first be activated. By tilting the red stick
completely to the right and then push the lever down
activates the accessory
The machine is equipped with a "dead man's handle",
once released the brush and drive will stop
immediately.
Differential lock - mechanical:

Disable see Figure 4-A

Enable see Figure 4-B
Pay attention while reversing. It is important that the
area is cleared, for any obstacle before reversing.
Never reverse the machine against a wall, tree or any
other fixed obstacle.

Operation safety zone

Do not leave the operation safety zone marked in fig 5,
while working with the machine. If it is necessary
toleave the operation zone, for example to readjust the
rotary brush or to attach an accessory, first stop the
engine.

Angle adjustment of accessory

The accessory can be pivoted 20 degrees to either
side. This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.

Troubleshooting

Problem Solution
The engine won't start:
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
The engine runs unevenly:
1. Check that the choke has been released.
2. Check fuel for impurities.
If the brush will not run:
1. Check that the clutch is adjusted
correctly.
2. Check that the belt is tight.
If the machine will not run:
1. Check that the clutch is adjusted
correctly.
2. Check the belt.
If the machine does not sweep effectively:
1. Check the distance between the brush
and working surface.

Technical specifications

Model
Length (mm)
Width (mm)
Height (mm)
Weight, dry (kg)
Wheel size
Engine model
Engine brand
9
Combi 800
80
70
100
56
4.8-8
TG720
Texas Powerline