Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Nip Arm Removal / Installation
The Nip Arm should be removed for clearing paper jams and cleaning the machine.
Nip Arm Removal
1. To remove the Nip Arm, turn the machine OFF.
2. Press the nip arm latch to the left (see above figures), grasp the right end of the Nip Arm,
pulling upward and remove.
3. Reverse this procedure to re-install the Nip Arm.
The DL400 will not operate until the Nip Arm is properly installed. Also, the nip arm assembly must
be removed if you want to increase/decrease the cut depth from the factory setting. Setting the cut
depth is described in this manual.
Figure 1.2 Press Nip Arm Latch
Figure 1.3 Lift Up and Remove
DL400 Letter Opener | 1-5
Operator Guide | SV60614 Rev
Publicité
Chapitres
Table des Matières
