General Characteristics Of The Operator; Main Operator Parts - Erreka CICLÓN Manuel De L'installateur

DESCRIPTION OF THE PRODUCT
2

GENERAL CHARACTERISTICS OF THE OPERATOR

The CICLON operator is constructed to form part of a
swing door automation system.
It comprises a metal body, which contains the motor
and a planetary gearbox. Allows a maximum opening of
approximately 130°.
The CICLON operator, along with its corresponding
Erreka control board, allows the implementation of a
soft-stop system, with the speed slowing down at the
end of the closing and opening operations.
3

MAIN OPERATOR PARTS

Fig. 2 Main components
40
Installation Manual
The CL210F (T2000VFI), CLS210F, CL250F, CLS250F
models have a brake and unlocking key to operate the
door manually in the event of failure or interruption of
the electricity supply.
The CLS210F, CLS250F models, apart from a brake and
release key, are fitted with an encoder.
With the CL210 and CL250 models it is always
necessary to install an electrical lock, and with other
models only for leaf lengths over 1.8 m.
The CL210, CL210F (T2000VFI) and CLS210F models
can be installed with articulated arm or slide arm. The
CL250, CL250F and CLS250F can be installed with slide
arm.
Components:
1 Operator body
2 Release lock (only in models with
brake)
3 Drag wheel
4 Wall bracket
5 Arm (not included with the
operator)
Cabling:
• Grey wire: motor (common)
• Brown wire: motor (rotation 1)
• Black wire: motor (rotation 2)
• Yellow/green wire: earth
• Orange wire:
no encoder: not included
with encoder: brake
• Purple wire:
no encoder: not included
with encoder: brake
• Blue wire:
no encoder: not included
with encoder: encoder signal
• White wire:
no encoder: brake
with encoder: common (–) of
the encoder
• Red wire:
no encoder: brake
with encoder: power supply (+)
of the encoder