Accessories - Stiga SP 386 Manuel D'utilisation

PROBLEM
6. No oil is released
7. The chain moves
when the engine
is running idle
8. The machine starts
to vibrate abnormally
9. The machine has
struck a foreign body.
If problems persist after having performed the above operations,
contact your dealer or an Authorised Service Centre.

16. ACCESSORIES

The "Correct bar and chain combination
table" contains a list of all possible
combinations between bar and chain,
indicating those which may be used on each
machine, marked with the symbol " ".
The same table also provides the
specification data for all chains and bars
approved for use on each machine.
Only use the replacement bars
and chains listed in the table. The use
of unapproved combinations may be
hazardous and cause serious injuries to
operators and damage the machine.
In consideration that the selection,
application and use of the bar and chain
are actions made solely by the user, at
his own discretion, the latter assumes
responsibility for damages of any kind
arising from such actions. When in doubt
or if lacking knowledge of the specifics
PROBABLE CAUSE
Poor quality oil
Lubrication holes are clogged
Incorrect adjustment
of fuelling
Damaged or loose parts.
Damaged or loose parts.
When the engine is cold, empty
the tank, clean it and the pipes with
liquid detergent and change the oil.
Clean them (chap. 8.1)
Contact the Authorised
Service Centre or dealer.
Stop the machine and disconnect
the spark plug cable (Fig. 31.A).
Inspect for damage.
Check and tighten any loose parts.
Have all checks, repair work
and replacements carried
out by an Authorised Service
Centre or dealer only.
Stop the machine and disconnect
the spark plug cable (Fig. 31.A).
Inspect for damage.
Check and tighten any loose parts.
Have all checks, repair work
and replacements carried
out by an Authorised Service
Centre or dealer only.
of each bar or chain, contact your
dealer or Authorised Service Centre.
EN - 20
REMEDY