Safety Regulations; Preparation; Personal Protective Equipment (Ppe); During Operation - Stiga SP 386 Manuel D'utilisation

2. SAFETY REGULATIONS

2.1 TRAINING
Become acquainted with the controls
and the proper use of the machine. Learn
how to stop the machine quickly. Failure
to follow the warnings and instructions
may result in fire and/or serious injury.
• Never allow children or persons
unfamiliar with these instructions to
use the machine. Local regulations
may restrict the age of the operator.
• Never use the machine if the user is tired or
unwell, or has taken medicine, drugs, alcohol
or any substances which may slow their
reflexes and compromise their judgement.
• Bear in mind that the operator or user is
responsible for accidents or unexpected
events occurring to other people or their
property. It is the user's responsibility
to assess the potential risk of the area
where work is to be carried out, and
to take all the necessary precautions
to ensure his own safety and that of
others, particularly on slopes or rough,
slippery and unstable ground.
• If the machine is sold or lent to others, make
sure that the operator looks over the user
instructions contained in this manual.
• It takes specific training to use the
machine for felling and delimbing.

2.2 PREPARATION

Personal Protective Equipment (PPE)

• Always wear slim fitting protective clothing
with slash-proof protection, anti-vibration
gloves, helmet, protective goggles, half-
mask respirator, protective earplugs, cut
resistant safety boots with non–slip soles.
• Never wear scarves, shirts, necklaces,
bracelets, clothing with flowing parts, laces
or ties or any hanging or flapping accessory
that could catch in the machine or in any
objects or materials in the work area.
• Tie your hair back if it is long.
Internal combustion engines: fuel
DANGER! Petrol and the fuel mixture are
highly flammable!
• Keep the petrol and fuel mixture in approved
fuel containers, in a safe place, away
from any naked lights or heat sources.
• Keep the fuel containers and storage
area free of sawdust, branches,
leaves, or excessive grease.
• Keep the containers out of
the reach of children.
• Do not smoke when preparing the
mixture, when filling or topping up with
fuel or when handling the fuel.
• Use a funnel to top up with
fuel only in the open air.
• Do not inhale fuel fumes.
• Never remove the tank cap or add
fuel whilst the engine is running
or when the engine is hot.
• Open the fuel tank slowly to allow the
pressure inside to decrease gradually.
• Do not approach the tank opening with
a naked flame to check its contents.
• If you have spilt some fuel, do not attempt to
start the engine but move the machine away
from the area of spillage and avoid creating
any source of ignition until the fuel has
evaporated and fuel vapours have dissipated.
• Immediately clean up all traces of fuel
spilt on the machine or on the ground.
• Replace caps of all fuel tanks
and containers securely.
• Never start the machine in the same
place in which you refilled it with fuel; the
engine must be started in an area at least
3 metres from where you refuelled.
• If fuel is spilt on clothing, change
clothing before starting the engine.

2.3 DURING OPERATION

Work Area
• Do not operate the engine in a confined
space where dangerous carbon
monoxide fumes can develop. All starting
operations must be carried out in an
open or well ventilated area! Always
remember that exhaust fumes are toxic.
• When starting up the machine, do not direct
the silencer and therefore the exhaust
fumes towards flammable materials.
• Do not use the machine in environments at
risk of explosion, in the presence of flammable
liquids, gas or powder. Electrical contacts
and mechanical friction can generate sparks
that can ignite the powder or vapours.
• Work only in daylight or with good artificial
light in good visibility conditions.
• Keep persons, children and animals away
from the working area. Ask another adult
to keep the children under supervision.
• Check that there is anybody within at least
15 metres of the machine's range of action.
• Where possible, avoid working on
wet, slippery ground or in any case on
uneven or steep ground that does not
guarantee stability for the operator;
EN - 2