EINHELL RUBIN Instructions De Montage page 8

Page 62
34
Assembly of the window stay
Important note: The window stay is supplied
unassembled in a separate bag. This bag contains all
the parts you need to assemble the window stay.
Repeat this step for the second and third window.
If you have purchased an automatic window stay
(available as an optional accessory) then you should
fit this in place of the one supplied with the
greenhouse.
34/a: Fit the ear onto the stay and attach it with the
M6x16 bolt. In order to ensure that the joint remains
mobile, avoid over-tightening the nut.
Page 63
34/c: To safely close the window, press the window
stay upward to the plastic web panel and hook it into
the window rabbet profile as shown in the profile
diagram.
Page 64
35
Assembly of covers and drains
35/a: Attach the cover to the profiles using two
4.2 x13 self-drilling screws with tapping screw
threads (item 8). If necessary, pre-drill holes
with the drill (diameter: 2 mm).
!
Important note:
Once you have finished assembling the greenhouse, check all nuts, bolts and
screws to ensure that they are all securely tightened. Tighten any that are loose.
8
ABA_RUBIN_Teil2_Titel+GB.pmd 8
Page 65
35/b + 35/c: The rain gutter end piece is attached to
the side strut using a 6.3 x 22 self-drilling screw with
tapping screw thread (item 7). If necessary, pre-drill
holes with the drill (diameter: 2 mm).Finally, punch
out the pre-stamped cutouts in the rain gutter at the
points at which water is to drain off (see Fig. 35/c).
Page 66
35/d: Slide the clamps onto the upper end of the rain
pipes. Then insert the pipes into the holes in the rain
gutter that you have just punched out in step 35/c –
refer to the illustration if required. Finally, tighten the
bolt/screw on the clamp to secure the rain pipe.
Please note: Make sure that the corner covers
engage in the floor profiles.
Page 67
Parts list: aluminum profiles (up to page 70)
Page 70
Parts list: plastic web panels
Note on replacement of the plastic web panels:
To replace a plastic web panel, remove the adjacent
clip profiles as described below.
First, loosen the bolts on the aluminum profiles to
which the relevant clip profiles are attached. You can
then gently press the aluminum profiles outward,
which will allow you to easily pull out the clip profiles.
Then replace the plastic web panel and reassemble
the aluminum profiles and the clips exactly as
described in the instructions.
07.04.2006, 09:48