Control Panel When Embroidering - Singer FUTURA XL-580 Manuel D'instruction

CONTROL PANEL WHEN
EMBROIDERING
When embroidering, the dials on the control panel are used to
step through the design color by color and within a color block.
After transferring desired design(s) to your FUTURA sewing
and embroidery machine, the display shows number of current
color block and total number of color blocks as illustrated.
The three horizontal lines indicate the beginning (bottom line),
middle and end (top line) of the current color block. As the
block is stitched out, a progress bar on the right side of the
display will show the approximate current position in the color
block.
STEP BETWEEN COLOR BLOCKS
To step between the transferred color blocks, press the center
of the lower dial. "BL" is shown on the display. The arrows
indicate which direction you can step between the color
blocks.
Turn the lower dial. The current color block number changes.
When having reached desired color block, press OK. The
block.
GO TO APPROXIMATE STITCH POSITION
WITHIN A COLOR BLOCK
To go to a certain part of current color block, press the center
of the upper dial. The horizontal line on the display indicate
the approximate current position in the color block.
Turn the upper dial clockwise to step forward, and counter-
clockwise to step backward in the design. Each step equals
one tenth of the color block.
Example: If a color block contains 150 stitches, each step
corresponds to 15 stitches.
When having reached desired position in the color block,
press OK. The hoop moves to that position. Fine tune by using
the Needle Stop Up/Down and Reverse buttons as described
on page 82 - 83.
102
Go to stitch position
Allez à la position de
couture
Vaya a la posición de
puntada
Step between
color blocks
Étape entre les
blocs de couleurs
Paso entre
bloques de color
OK
OK
OK