Hema 80.00.5001 Mode D'emploi page 6

FEATURES
1. Measuring cap
2. Lid
3. Lid seal ring
4. Jug
5. Blade assembly
6. Bottom seal ring
7. Motor base
8. Control knob
Switch speed setting
1. P = Pulse
2. 0 = Off
3. 1 = Low
4. 2 = High
HOW TO USE
Caution: Make sure the motor base is unplugged from the power source and the control knob is set at the
position 0.
1. Place the jug onto the motor base. Rotate the jug clockwise to have it locked on the motor base. The blender
will not work if the jug isn't locked into the motor base properly.
2. Put the liquid and diced food into the jug (no more than 1 L). Never fill the jug with ingredients that exceed
70°C.
3. Put the lid onto the jug. Make sure it is placed firmly onto the jug.
4. Insert the measuring cap into the middle of the lid.
5. Put the plug into the power outlet. Switch on the appliance by rotating the control knob to choose the speed
1, 2 or pulse function.
6. After use, rotate the control knob to the position 0 and remove the plug from the outlet.
Note:

For quick or delicate blending tasks, turn the control knob to the P position and hold it for a few seconds.
Operate several times until the consistence you want is obtained.

When crushing a great quantity of ingredients, keep one hand upon the lid to make sure the lid is firmly in
its place.

For each use, the consecutive operation time should not exceed 3 minutes. At least 10 minutes of rest time
are required between two continuous cycles. Let the appliance cool to room temperature before performing
the next operation cycle.

To crush ice, add up to 6 ice cubes each time.

Never blend large pieces of solid food, frozen food and bones in the appliance as it may cause damage.
CLEANING AND MAINTENANCE
Caution:
Handle the blade assembly with care as the blades are sharp!
Only the jug and blade assembly can be cleaned in a dishwasher and the temperature setting of the dishwasher
should never exceed 70°C.
Never use any water or liquid more than 70°C to clean any detachable parts.
1. Fill the jug half-full with water (< 70°C) and a little cleaning agent. Turn the control knob to P position for a
few seconds.
- 5 - 80.00.5001