Bestron AIRP200UV Mode D'emploi page 25

EN
SLEEP RESET
Use this button to turn on SLEEP MODE. When SLEEP MODE is activated, the indicator light flashes 10 times
before all indicator lights dim. The device will also go to the most silent ventilation mode. This way you can sleep
more peacefully while the device continues to work.
You can press any button to cancel SLEEP MODE.
Press and hold the button for 3 to 5 seconds to turn off the RESET indicator after cleaning and/or replacing the
filter.
See also the chapter FILTERS.
Timer Function
Use this button to activate the timer function. The timer switches the appliance off after the set time.
Press once = The device switches off automatically after 2 hours. The indicator light comes on.
Press twice = The device switches off automatically after 4 hours. The indicator light comes on.
Press 3 times = The device switches off automatically after 8 hours. The indicator light comes on.
Press 4 times = The timer function is switched off again. No indicator lights are on.
OPERATION - Filters
3-WAY FILTER
This device is equipped with a 3-way filter that lasts about 6 months. When the RESET indicator comes on,
it is time to replace the filter. Do this according to the following instructions.
1. Remove the plug from the socket.
2. Open the lid by pulling it forward.
3. Pull the filter forward by the two side strips, clean it and reinstall it. Or install a completely new filter.
Tip:
To better clean the filter, you can carefully peel off the microfilter layer. Place it back neatly after cleaning.
Tip:
Clean the combination filter with the small brush of your vacuum cleaner. This removes dust and dirt.
4. Put the lid back on the device.
5. Press and hold the SLEEP RESET button for 3 to 5 seconds to reset the program system. The operating
control light will turn off.
UV-FILTER
This device is equipped with a UV-lamp with a lifespan of approx. 20,000 hours. We recommend that the
lamp be replaced by a recognised installer.
3
4
1 2 3 4
25