Troubleshooting; Possible Causes - Scheppach 88001951 Traduction Des Instructions D'origine

13. Troubleshooting

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before
carrying out maintenance work.
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in normal
operation.
Saw blade swings out
Holders not aligned straight
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible causes

Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed down
or is on the motor
The motor is not secured
Holders not aligned
DE
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt
to repair the motor yourself as this
should be carried out by trained
personnel.
Refer to the instructions given earlier in
this manual for information on installing
the saw
The heavier the work bench is,the
less the vibration. A bench made from
ply wood always vibrates more than
one made from solid wood. Select the
work bench best suited to your working
conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the
holders are fastenedto the arm.
Align the holders so that they are
perpendicular to each other and
retighten the screws.
GB
FR
23 / 40