Table des Matières
Publicité
13
a
F2
15
Y
16
14
14
14
F1
b
b
Mount the adapter plate
Push the holder of the adapter plate (F2) into the opening at the
front of the support arm (F1). Make sure that the holes in the adapter
a
plate holder and support arm (a) are in line.
Insert the bolt (Y) from the side until it is flush (fig. 15). You can
knock it in carefully with a hammer if it proves difficult.
Tighten the grub screw (b) on the bottom with an Allen key (fig. 16).
This screw stops the bolt (Y) from coming loose.
Publicité
Table des Matières
