HumanTechnik lisa Mode D'emploi page 10

Use the adhesive ring to glue the
Smoke detector connection
microphone next to the sound outlet of
your smoke detector (see illustration)
and plug the microphone cable into
the connection jack on the bottom of
the transmitter. To do this, pull off the
backing foil from the adhesive ring on
the microphone.
Installation example
For optimum function of the transmit-
ter, its sensitivity dial switch must be
set so the transmitter reliably
responds to the smoke detector.
1. Set the sensitivity dial switch to its
Setting the sensitivity
lowest level (turn to the anticlock-
wise to stop).
2. Activate the test alarm of the
smoke detector and gradually in-
crease the
transmitter (by turning the dial
clockwise) until the transmitter
reacts to the smoke detector.
10 English
sensitivity of
All lisa devices connected to the
Important note
mains supply have a low power con-
sumption which may lead to the devi-
ce feeling warm. This is normal and
does not interfere with the normal
function of the devices.
These signalling systems have a high
operational safety. Should any faults
occur in spite of proper installation
and use, please contact your dealer.
High and low voltage spikes (e.g.
during a thunderstorm) can occur on
the mains supply. The lisa devices
have an integrated electronic control-
ler which may stop working after these
conditions. If this happens simply
unplug each of the devices and plug
them in again.
As a precaution remove all devices
from their sockets during a thun-
The use of halogen lamps or other derstorm.
equipment (e.g. Microwave Ovens)
may, in rare cases, interfere with the
lisa signals. In these cases the use of
mains filters or suppressors is advisa-
ble. Please ask your dealer.
All lisa devices are maintenance free. Maintenance and care
To clean, remove from the mains sok-
ket and wipe with a moistened cloth.
Never use cleaning agents.
lisa devices should not be exposed to
the
excessive heat, dust, humidity or
mechanical shock.