Important - tau K892M Notice D'installation

n°9 ON: pressure-sensitive edge on.
OFF: pressure-sensitive edge off.
n°10 ON: internal push-button panel off. The OPEN/CLOSE and STOP buttons on the lid of the
automation are off. Therefore it is not necessary to short circuit the terminals.
OFF: internal push-button panel on. The OPEN/CLOSE and STOP buttons on the lid of the
automation are on.

IMPORTANT:

Each pair of terminals attached to an NC contact that is not in use must be short-circuited in order
to ensure the proper operation of the board.
The input related to the pressure-sensitive edge must not be short circuited. The device is turned
off by setting dip 9 to OFF.
The door's earthing system must comply with current standards. The manufacturer will accept no
liability for any damage deriving from failure to comply with this requirement.
The radio receiver can learn up to a maximum of 8 dip-switches (TXD2, TXD4, BUG2, BUG4) or
rolling codes (BUG2R, BUG4R) which can be set on the two channels as required.
The fi rst channel directly commands the control board for opening the automatic device; the second
channel commands a relay for a N.O. no-voltage output contact (terminals 9 and 10, max. 24 Vac,
1 A).
The learning mode (dip-switch or rolling code) is determined by the fi rst radio control device and
remains unchanged until all the codes have been cancelled.
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P1 = OPEN/CLOSE
P2 = 2nd channel
1_ press button P1 briefl y to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL8 turns off to indicate that the code learning mode has been activated (if no code is
entered within 10 seconds, the board exits the programming mode);
3_ press the button of the relative radio control device;
4_ LED DL8 turns on again to indicate that the code has been memorised (if this does not happen,
wait 10 seconds and start again from point 1);
5_ to memorise codes to other radio control devices, repeat the procedure from point 1 up to a
maximum of 8 transmitters;
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2
instead of P1;
7_ to exit the learning mode without memorising a code, press button P1 or P2 briefl y.
N.B.: if the maximum number of codes (8) is exceeded, LED DL8 fl ashes rapidly for about 3
seconds without memorising the code.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control
devices;
2_ LED DL8 fl ashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL8 turns off for approx. 3 seconds and then remains steady to indicate that the code has
been cancelled;
14
433.92 MHz BUILT-IN RADIO RECEIVER
K892M