Rear Panel - Yamaha MS300 Mode D'emploi

Rear Panel

A
POWER switch
This switch turns the power to the MS300 on and
off. When you turn this switch on, the POWER
8
indicator ( ) lights up green.
B
AC IN connector
Connect the included power cord here.
C
LINE connectors
These balanced connectors accept input from
line-level sources, such as a mixer. The connec-
tors include: an XLR-3-31 type; an XLR-3-32
type; a 1/4" TRS phone jack. They are all con-
nected in parallel and can be used as line outputs.
In this case, input signals from the MIC connec-
5
tor ( ) will not be output.
D
LINE LEVEL control
This control enables you to adjust the level of sig-
nal input from the LINE connectors (
E
MIC connector
Mic-level sources are input at this balanced,
XLR-3-31 type connector. The internal low-cut
filter will cut the range of these signals below
70 Hz. The mic input will not be routed to any
destination other than the speaker.
4
1
3
).
9
2 1
3
3
1 2
2 3 4
F
MIC control
This control enables you to adjust the level of sig-
nal input at the MIC connector (
G
MASTER LEVEL control
This control enables you to adjust the entire vol-
ume level.
H
POWER indicator
When you turn the power on, this indicator lights
up green.
I
EQ control
LOW: This EQ adjusts the low band in the range
of 0 ~ –8 dB with a center frequency of 55 Hz.
The 0 (MAX) setting is flat. Turn the control
couterclockwise to cut.
HIGH: This EQ adjusts the high band. The arrow
setting
boost and couterclockwise to cut the HF band
(1.6 kHz or higher) in the range of ±3 dB.
2 1
3
is flat. Turn the control clockwise to
8
7
6
5
5
).