InPro 6000 Series Optical O
8
Product specification
8.1 Certificates
Each sensor is delivered with a set of 3.1 certificates
(complying with EN 10204.3 / 1.B).
All wetted metal parts (sensor shaft, cap sleeve and
O ptoCap) are identified with a engraved symbol cor-
responding to the heat number on the p aper c ertificate
delivered with the sensor.
Each wetted metal part (sensor shaft, cap sleeve and
OptoCap) is polished in order to get a surface roughness
lower than 0.4 µm (16 µin). This represents a roughness
grade number of N5 (according to ISO 1320: 1992).
8.2 Specifications
Measurement principle
Working conditions
Permissible pressure range
during measurement
Mechanical pressure resistance
Permissible temperature
range during measuring
Mechanical temperature
resistance of the sensor shaft
Analog / digital Interface
nA Output: (InPro 6860i /../ nA)
mA Output: (InPro 6860i /../mA
Analog temperature Output:
Digital Interface:
Power requirements
© 01/ 2016 Mettler-Toledo GmbH InPro 6000 optical O
Printed in Switzerland
Sensors 12 mm
2
InPro 6860 i / 6870 i /
6960 i / 6970 i
optical
InPro 6860 i / 6870 i:
0.2 ... 6 bar absolute
2.9 ... 87 psi absolute
InPro 6960 i:
0.2 ... 9 bar absolute
2.9 ... 130.5 psi absolute
InPro 6970 i:
0.2 ... 12 bar absolute
2.9 ... 174 psi absolute
InPro 6860 i / 6870 i:
max. 6 bar absolute
max. 87 psi absolute
InPro 6960 i / 6970 i:
12 bar absolute
174 psi absolute
InPro 6860 i /
InPro 6870 i:
0 ... 60 °C
32 ... 140 °F
InPro 6860 i :
– 20...140 °C
– 4...266 °F
steam-sterilizable – 4...250 °F
autoclavable
60 nA at air (25 °C, 1013 mbar)
4 to 20 mA (active)
NTC 22 kΩ
Modbus RTU on RS485
– Baudrate:
4800,9600, 19200 (default),
38400, 56600, 115000
– Device address: 1 (default to 32)
U
= 19.5 VDC
min
U
= ≤ 25 VDC
max
P
= 0.75 W ➝ 33 ... 40 mA
max
29
InPro 6960 i /
InPro 6970 i /:
0 ... 40 °C
32 ... 104 °F
InPro 6870 i /
InPro 6960 i /
InPro 6970 i:
– 20...121°C
steam-sterilizable
sensors
2
52 206 256