Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Programming the remote control
Caution
• Risk of injury by electric shock.
• Must be installed by an authorised electrician!
• Only the back of the hand is protected by the device. No protection
against accidental contact!
• The programming button must be operated with an insulated tool.
• The switched current of the device must be observed at all times.
Note
Before entering this VC421 transmitter, be sure that first a master
transmitter was programmed into the receiver and the motor learned
the upper and lower stops.
Please refer to the operating instructions for the receiver.
Programming VC421
a) Press the programming button of the master transmitter until acknowledge-
ment is given by the receiver.
b) Now press the programming button of the new transmitter until acknowl-
edgement is given by the receiver
c) Then press the programming button of the new transmitter to be learnt once
again.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m outside and inside the building and up
to 350 m in the open.
de
en
fr
nl
17
Publicité
Table des Matières
