Safety Instructions; Use; Assembly - DeVilbiss Healthcare Drive TSE 120 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Safety instructions

• Do not use if there are any defects!
• Caution – risk of slipping/falling!
• The lid must not be used as a backrest in the opened
position!
• The lid must not bear a load when closed (by sitting on
it, for example)!
• Check the raised toilet seat regularly for a secure fi t on
the toilet bowl. Retighten the knurled nuts if necessary.
• Take note of the permitted maximum weight of the
user. This information can be found in the technical
data in these instructions for use as well as on the
identifi cation plate.

Use

The raised toilet seat TSE 120 is suitable for nearly all
standardized or commercially available toilet bowls.

Assembly

Remove the seat and lid from the toilet bowl.
Assembly is carried out without tools.
TSE 120:
Place the rear of the support on the ceramic bowl (B)
with the fi xing screws (F). Screw in the knurled nuts (G)
from below but do not tighten them yet. Align the rear of
the support on the center of the ceramic bowl and tight-
en the knurled nuts (photo 1).
1
C
G
F
Insert the adjustable holders (C) at the desired height
(8.5 / 12 / 15.5 cm) on the rear of the support (B) on the
right and left (photo 2).
2
B
C
8,5 cm
15,5 cm
Drive Medical GmbH & Co. KG | As per: 24.03.2020 | Errors and alterations excepted
C
B
G
F
C
C
12 cm
To adjust the height in the
front, insert the supports
(D) in the corresponding
opening until they audibly
click into place (photo 3).
• Take care that the front
supports (D) on the
right and left are each
inserted at the same
height.
• The front supports (D)
can be set lower than the rear support (B).
• Insert the two braces (E) in the corresponding open-
ings in the rear until they audibly click into place
(photo 3).
• Insert the body of the raised toilet seat (A) into the
adjustable holders (C). In doing so, the adjustable
holders (C) must engage with the locking tabs (L) in the
body (A) (photo 4+5).
4
C
5
L
A
The adjustable holders (C) can only be inserted in one
direction into the raised toilet seat.
Instructions for use TSE 120 / TSE 120 Plus
EN
C
J J
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Drive tse 120 plus

Table des Matières