Ingress Protection - WIKA P-3 Série Mode D'emploi

6. Commissioning, operation
Bayonet connector
2-wire
U + A
U - B
S + -
Specifications
Description
Angular connector DIN 175301-803 A
Circular connector M12 x 1 (4-pin)
Circular connector M16 x 0.75 (5-pin)
Bayonet connector
CANopen M12 x 1 (5-pin)
USB
Cable outlet
The stated ingress protection (per IEC 60529) only applies when plugged in using mating connectors that have the
appropriate ingress protection.
6.3 Functional check
The output signal must be proportional to the prevailing pressure. If this is not the case, this may indicate
a damaged diaphragm. In this case, see chapter 8 "Faults".
6.4 Installation of the service interface
Only required for analogue instruments
WIKA operating instructions pressure transmitter, model P-3x
3-wire
A
B
C

Ingress protection

IP65
IP67
IP67
IP67
IP67
IP67
IP67
EN
19