Maintenance; General Maintenance; Cleaning/Replacing The Filter - Ryobi ONE+ P724 Manuel D'utilisation

REMOVING THE ROLLER BRUSH FOR
CLEANING
See Figure 12, page 10.
The roller brush is located inside the roller bar assembly.
The roller bar assembly has a tool-free end cap, allowing
the roller brush to be easily removed for cleaning.
To remove:
 Insert a coin into the slot on the end of the roller brush
as shown. Rotate the end cap approximately 1/4 in.
counterclockwise to unlock the roller brush.
 Slide the brush to release the cap and pull the brush from
the roller bar assembly.
This product contains no serviceable parts.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.

CLEANING/REPLACING THE FILTER

See Figure 13, page 10.
 Remove the battery pack and the dust bowl.
 Remove the filter assembly by pulling it out of the dust
bowl.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
OPERATION

MAINTENANCE

FRENCH AND SPANISH LANGUAGE SECTIONS.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller brush using the scissor
grooves.
To reattach:
 Insert the roller brush into the roller bar assembly.
 Align the tabs on the cap to the notches on the roller bar
assembly and firmly press the cap into place.
NOTE: Make sure the opposite end of the roller brush is
aligned to the drive spindle when pressing the cap into
the assembly housing.
 Turn the end cap 1/4 in. clockwise with coin to lock into
place.
 Shake or lightly brush any dust or dirt off the filter
assembly.
 Remove the prefilter by lightly pulling on one of the tabs
and sliding away from the assembly. The prefilter may be
rinsed if necessary.
 Empty the dust bowl; wash if necessary. Before
reattaching to the vacuum, make sure all pieces are
completely dry.
 Attach the prefilter to the filter by inserting the base of
the filter into the indent of the prefilter and snapping the
tabs into place.
NOTE: Carefully spread the tabs to help align and snap
them into place.
 Install the filter assembly into the dust bowl. Reattach
the dust bowl by aligning the slot on the bottom of dust
bowl with the tab on the bottom of motor housing, then
snap the two sections together.
When purchasing a replacement filter assembly, request
recommended part number 316342001.
7 — English