Ryobi ONE+ P724 Manuel D'utilisation page 6

TURNING OFF THE ROLLER BRUSH
See Figure 3, page 8
The roller bar can be used with the roller brush turned off.
To cancel the roller brush:
 Press the roller brush ON/OFF button, located below
the high/low speed button to cancel the use of the roller
brush.
To reactivate the roller brush:
 Press the roller brush ON/OFF button again to turn the
roller brush back on.
NOTE: If vacuum is turned off while the roller brush is off,
when the vacuum is turned back on, the roller brush will
default to the ON setting.
USING THE ROLLER BAR
See Figures 4 - 5, page 9
The roller bar can connect directly to the vacuum for cleaning
upholstery and stairs or attach with the extension wand for
normal floor vacuuming.
NOTE: When not in use, always store the unit on the charger
base or lie flat to prevent falling over. Never stand alone in
the upright position.
To connect:
 Switch off unit and remove the battery pack.
 Align the pins on the roller bar with the receptacle in the
stick vacuum or extension wand.
 Press together until it clicks into place.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
ATTACHING AND REMOVING THE EXTENSION
WAND AND ACCESSORY TOOLS
See Figure 6, page 9
The extension wand and accessory tools can be used together
or separately for a variety of cleaning tasks.
To connect:
 Switch off unit and remove the battery pack.
 For the extension wand, align the pins on the extension
wand with the receptacle in the stick vacuum.
 Press together until it clicks into place.
OPERATION
 For accessory tools, insert the tool into the outlet of the
stick vacuum or the extension wand.
 Press together until it fits securely.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
EMPTYING/REMOVING/REATTACHING THE
DUST BOWL
See Figures 7 - 10, pages 9 - 10.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To empty:
 Remove the battery pack.
 Hold unit over waste receptacle.
 Press lock button on bottom of bowl to release spring
loaded door.
 Shake lightly or tap sides to dislodge debris.
 Close door, pressing firmly until lock button engages.
To remove:
 Remove the battery pack.
 Push the release button located on the side of the
vacuum. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
REMOVING BLOCKAGES AND CLEANING
THE ROLLER BAR
See Figure 11, page 10.
Obstructions in the roller bar may activate the overload
protection sensor and must be removed. The roller bar will
stop and the light on the roller bar illuminates red.
To reset:
 Remove the battery pack.
 Remove the roller bar assembly from the wand or stick
vacuum base and clear any obstructions with a blunt
object.
 Wait at least 1 minute before reattaching the assembly.
For use with P726 or P7191 Roller Bar
6 — English