Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Moving the unit and setting it up.
•
Since the unit is very heavy (approximately 63 k
•
Put the unit down slowly and carefully watch your step.
•
Do not drag or push the unit in an installed state.
The floor may be damaged.
•
Do not move the unit with a person sitting on it.
Failure to observe this precaution may result in accidents or injuries due to the unit fallen down.
Lifting the unit to install and setup the unit
•
You may damage the floor by dropping the unit if you do not
hold it correctly.
Place the controller and the
power cord on the seat.
Placement area
(place a mat, etc.)
Do not hold here.
Doing so may result
in damage or injury.
Hold the plastic part.
Install the unit with the backrest away
from the wall.
Make sure the backrest does not touch the wall.
More than 10 cm
(When the backrest is fully upright)
(When the backrest is fully reclined)
g), be careful to avoid back injuries. (The unit must be carried by two persons.)
Using the wheels to move the unit
After procedures 1 to 5 on page 11;
Hook your fingers on the
stiff plastic part inside.
Connect the power cord to the unit
At least 3 cm
•
When moving the unit with the wheels, place a mat etc. on the floor.
Failure to observe this may cause damage to the floor.
1) Press the
button to return
the back rest to its original position.
2) Slide the power switch to the "off" position
and unplug the unit.
Lift it no higher than waist height.
Place the controller
and the power cord
on the seat.
Do not hold here.
Doing so may result in dam-
age or injury.
Hold the plastic part.
1) Check for dirt and damage on appliance inlet
of the power switch section and the
connector of the power cord.
2) Insert the connector into the appliance inlet.
3) Be sure to push the connector in all the way.
Mat, etc. Wheels
Appliance
inlet
Connector
9
Publicité
Table des Matières
