Equipment Controls; Control Panel Pictograms - Walter Surface Technologies SURFOX TURBO Manuel De L'utilisateur

Équipement de nettoyage des soudures
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Introduction
Amperage
Before connecting this unit, check that the amperage shown
on the rating plate is the same as the power supply.
Operating this unit on an amperage other than specified on
its rating plate may result in personal injury to the user and
damage the unit.
Preventive maintenance
After use, allow the tip to cool and remove the cleaning
pad. Neutralize with Surfox-N liquid or FT-100 and rinse the
cleaning pad and wand tip with water and dry. Clean dust
and dirt deposits from the exterior of the unit. Keep all vent
openings free of any obstructions. Clean the power cord to
prevent deterioration and check for possible damage to cord
and plug.
Note: Damaged cords must be replaced immediately by
qualified personnel only. Refer to Spare Parts List for the
ordering number.
Transportation
Before transporting the machine, remove the electrolyte
solution cartridge and make sure all connecting lines are
disconnected. The machine must be carefully packed in a
suitable container and properly protected. WALTER will not
be held responsible for any damages resulting from leaked
cleaning solution or rough handling.
Storage
If the machine is to be stored for any length of time, the
cleaning pad must be removed
(neutralized, rinsed and left off) and the insert neutralized,
rinsed and dried. Store in a dry safe place to avoid damage,
especially to the electronic components.
Waste Disposal
Dispose of residual waste in compliance with Federal,
Provincial, State and local environmental regulations. Refer
to WALTER Material Safety Data Sheet of the SURFOX
electrolyte cleaning solutions.
Extension cord
When an extension cord is needed, use wire size 14 (AWG)
for up to 50 feet (15 meters) and size 12 (AWG) for 50 to
100 feet (15 to 30 meters).
6

Equipment Controls

Equipment Controls

Control Panel Pictograms

Brush
Outlet for
Turbo-wand
Pad
Outlet for
ground
connector

Publicité

Table des Matières
loading

Table des Matières