KitchenAid 720-0826E Instructions D'installation Et Guide D'utilisation Et D'entretien page 32

Change Grill Main Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the 2 screws and cotter clip that hold the burner in
place. Set the screw and clip aside.
3. Remove the burner from the grill by lifting the burner out.
4. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of gas valve. The
main burner NG orifice is located behind the LP orifice, so
no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly
removed inside of the burner opening.
5. Reinsert the burner by sliding the middle tube of the gas
burner over the gas orifice and reattach using the cotter
clip previously removed. Repeat the procedure for each
main burner.
6. Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Change the Sear Burner Orifice
1. Use a screwdriver to remove screw from the igniter pin.
A
32