Scrap - Erreka VIVO-D103 Manuel De L'installateur

MAINTENANCE AND TROUBLESHOOTING
Problem
Once opening is programmed, the
door comes down at slow speed
The operator only works at slow
speed
The operator does not work,
DL8, DL9 and DL10 lit up
DL2 lit up
DL1 off when operating the key
devices
The operator does not work,
DL8, DL9 and DL10 lit up
DL2 lit up
DL1 lights up when pressing ST1, ST2
and DL11 and DL12 light up
The operator does not work,
DL8, DL9 and DL10 lit up
DL2 lit up
DL1 lights up when pressing ST1, ST2,
and DL11 and DL12 remain off
The leaf does not reach the stopper
The leaf does not reach the stopper
DL2 off, DL6 on
T h e d o o r d o e s n o t m a k e t h e
programmed speed changes
The door opens but does not close
DL2 off
The door opens but does not close
DL3 remains on
The door opens but does not close
DL3 remains off
The door opens but does not close
DL4 remains off
4

SCRAP


The control board, up until the end of its useful life,
must be dismounted at its location by an installer
who is as well qualified as the person who
completed the assembly, observing the same
precautions and safety measures. In this manner
possible accidents and damage to adjacent facilities
will be avoided.
54
Installation Manual
Cause
Open door position has not been
stored: before reaching the opening
limit switch, the maximum thrust
adjusted through PM.A has been
exceeded
Absence of control board power
supply, with the control board running
off the battery
The open/close of the door has only
been programmed at slow speed.
The key device signal does not reach
the control board
Motor fuses F2 and/or F3 blown
Operator connections
Operator, transformer or control board
faulty
Limit switches poorly connected or
constantly activated (DL3 or DL4 off)
Control board failed
Opening programming incorrect
Limit switches wrongly adjusted
Operator sensitivity very high, not
suitable for the weight of the door
Crankshaft incorrectly positioned
The photocell has detected an obstacle
The operation has not been properly
stored
Absence of control board power
supply, with the control board running
off the battery
There is a safety item activated (in
closing)
The control board is programmed in
step-by-step mode
Opening limit switch activated, poorly
connected or deteriorated
Closing limit switch activated, poorly
connected or deteriorated
}
The control board must be deposited in the
appropriate containers for subsequent recycling,
separating and classifying the different materials in
line with their nature. NEVER deposit it in domestic
rubbish or in landfills which are not suitably
controlled, as this will cause environmental
contamination.
Solution
Check that there are no obstacles or hard
points in the door run. If necessary,
increase the set value through PM.A.
Reprogramme the opening run
Restore the power supply
Programme the open/close as described in
"Programming the opening and closing
run" on page 49.
Check the key devices and the connections
Replace F2 and/or F3 with another fuse of
the same value and investigate the cause of
failure of F1/F3
Check connections
Call the technical service
Check the limit switch
Call the technical service
Carry out the programming correctly
Adjust the limit switches
Adjust the sensitivity of the operator
Correct the slant and position of the
crankshaft
Check the possible obstacles
Store the operation again with the door
closed
Restore the power supply
Remove any possible obstacles
Programme it in automatic mode, where
appropriate
Check the limit switch
Check the limit switch