Maintenance And Inspection; Trouble Shooting; Environmental Protection; Available Accessories - Powermatic 719T Mode D'emploi

The tilt table is heavy. When raised, take
extra precaution not to let it drop on hands or fingers.
Injury can result.
Loosen bolt (C, Fig 8) with the wrench provided.
Pivot the table to adjust the angle up to 35° using the scale
(D, Fig 8) on the tilt bracket as a guide.
Tighten the bolt (C).

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair work may only be
carried out after the machine is protected against
accidental starting by pulling the mains plug.
The mortise requires only minor maintenance, such as
lubrication, routine adjustments and sharpening of chisel and
bit.
Clean the machine regularly.
Defective safety devices must be replaced immediately.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Chisel clogged with chips
*Clearance chisel to bit not enough-
set bit 1.5 to 4mm below chisel.
*chips cannot clear the chisel-
observe chisel slot and working order.
Burned Wood
*Feed too slow-
increase feed rate.
*Worn chisel or bit-
sharpen chisel and bit.
Fig 8

10. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.

11. Available accessories

Stock number 6285526
6.35 mm chisel and bit
Stock number 6285527
8 mm chisel and bit
Stock number 6285528
9.5 mm chisel and bit
Stock number 6285529
12.7 mm chisel and bit
Stock number 6292447
15.87 mm chisel and bit
Stock number 6292448
19 mm chisel and bit