Select Display Profile; Troubleshooting - Conrad 75 15 92 Notice D'emploi

16. Select display profile

The following preset display profiles are available:
17. STANDARD
18. SOFT
19. LIGHT
20. MEMORY
21. VIVID
Press the "P.P" button (17) on the remote control repeatedly the select the desired display profile.
Every display profile has different presets for brightness, colour

17. Troubleshooting

Status Possible cause
No picture • The power supply plug is defective.
• No video signal
• The monitor is in standby mode or
No colour • Your surveillance camera does not
display
No sound • The monitor is muted
30
or the power supply used is
unsuitable
turned off
support PAL video format
Possible solution
Replace power supply plug
Check the connections
and the cables between the
cameras and the monitor.
Press the ON/OFF switch (8) on the
monitor to turn on the monitor.
When the monitor is in standby mode,
the red "Standby" LED (3) is on. In this
case, press the "Standby" button (11)
on the remote control.
Make sure your camera supports
video format.
Press the MUTE button (14) on the
remote control.
When the monitor is muted, a loud-
speaker symbol with an "x" to its right
is displayed.
, and contrast.