What If There Are Problems; Replacement Parts And Wearing Parts - Beurer ELLE MPE 100 Mode D'emploi

1. Press the ON/OFF button
If the safety lock is not turned to the closed position, the device cannot be switched
on.
2. Select the desired speed using the speed controller.
3. Select the desired direction of rotation using the buttons for clockwise and anti-clockwise
rotation.
4. Do not press too hard and always carefully move the attachments towards the area to be tre-
ated. Move the device towards the area to be treated and apply slight pressure while slowly
moving the device in circles.
If a large amount of pressure is placed on the rotating attachment, the device automa-
tically switches off. Press the ON/OFF button again to switch the device back on.
5. Apply moisturiser to the treated areas after each use.
5. Cleaning
Warning
Before beginning cleaning, always pull the mains adapter out of the socket!
• Clean the base station and the hand-held device with a damp cloth. If it is very dirty, you can
also moisten the cloth with a mild soapy solution.
• For hygienic reasons, you may use alcohol and a cloth or brush to clean the attachments. Al-
low the attachments to dry afterwards.
• Do not use any chemical or abrasive cleaning agents.
• Ensure that no water enters the device. If this should happen, reuse the device only when it
has fully dried out.
• Do not submerge the base station and mains adapter in water or any other fluids.

6. What if there are problems?

Problem
Hand-held device will
not switch on.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding listed service
address under the stated material number.
Replacement part
Fine sapphire cone
Coarse sapphire cone
Felt cone
sapphire wheel (fine)
Sapphire wheel, coarse
Cylindrical cutter
Flame-shape cutter
to start treatment.
Possible cause
Mains adapter not plugged in
No voltage at mains socket
Hand-held device not connected to
base station.
Material number
163.301
163.302
163.303
163.304
163.305
163.306
163.307
Solution
Insert the mains adapter into the
socket.
Check your fusebox.
Connect the hand-held device to
the base station.
14