Assembly - Ryobi RY80518 Série Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Spray Wand Storage Bracket
Screws (2)
Storage Bracket Mounting Pad
Quick-Connect Nozzles (3) with Nozzle Storage
Detergent Injection Hose
Handle
Wheel (2)
Axle (2)
Hitch Pin (2)
4-Cycle Engine Lubricant (SAE 30)
Disposable Funnel
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, and wheels. Remove the hitch
pin from the axle.
 Slide the axle through the hole in the center of the wheel.
 Lift the machine and slide the combination into the wheel
mounting hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in
place.
ATTACHING THE SPRAY WAND STORAGE
BRACKET
See Figure 4.
 Place the storage bracket mounting pad over the holes
in the frame.
 With holes aligned, place the spray wand storage bracket
on top of the mounting pad.
 Insert a screw through each of the holes and tighten
securely.
ATTACHING DETERGENT INJECTION HOSE
See Figure 5.
Before detergent can be used with this machine, the detergent
injection hose must be attached.
 Push the open end of the clear detergent injection hose
securely over the fitting as shown.
NOTE: Keep injection hose away from hot surfaces.
Page 8 — English