Installing Chain Suspended Units - Hatco Glo-Ray GRAM Série Manuel D'installation Et D'utilisation

INSTALLATION
Shelf with 3/4" (19 mm)
flanged edge
Lowest edge of
flanged shelf.
Adjustable
Angle
Bracket
Flanged Shelf Installation
1. Position the unit on a flat surface with the heating element
facing down.
2. Remove the two center screws from the end plate at one
end of the unit. These screws do not need to be replaced.
(This step does not apply to GRNM models.)
3. Remove the two upper end plate screws.
4. Align the appropriate holes on the adjustable angle bracket
with the end plate mounting holes on the unit. Secure the
angle bracket with the end plate screws.
5. Repeat steps 2 – 4 for the opposite end of the unit.
Removed
Center Screws
End Plate
Screws
Adjustable
Angle Bracket
Adjustable Angle Bracket Installation
6. Fasten the angle brackets to the underside of the shelf
using appropriate fasteners (not supplied by Hatco).
NOTE: Two pairs of brackets will be needed for dual units.
Two adjustable
angle brackets
on each end
for dual units.
Dual Unit Mounting

Installing Chain Suspended Units

Chain suspension mounting attaches a strip heater to an
overhead surface with the use of "S" hooks. Chain suspended
1" (25 mm)
Gap
units are available for single housing GRAM models only.
Minimum
NOTE: Units ordered with the "S" hook option come with two
For installation with chains, make sure the chains have
sufficient strength and are securely fastened to both the
unit and the mounting location. Poorly installed chains may
cause the unit to loosen and fall. Do not place anything on
top of units installed with chains.
To ensure safe and proper operation, refer to the "Minimum
Clearance Requirements" listed in the Installation section
of this manual.
NOTE: The strength of the chain supplied by Hatco is sufficient
NOTE: Dual units cannot be mounted using the "S" hook and
1. Prepare the overhead mounting system for the "S" hooks.
Make sure the system is secure and is set up so the unit
will be suspended at a level, safe, and proper distance
from walls, counter, and food.
2. Loosen, but do not remove the screws securing the hanger
tabs on each end of the unit. Rotate the tabs up, then
tighten the screws securely.
3. Securely attach one of the 6" (152 mm) connecting chains
between each pair of hanger tabs.
4. Attach an "S" hook to the center of each connecting chain.
5. Carefully lift the unit and attach the "S" hooks on each end
of the unit to the overhead mounting system. Make sure
the unit is level.
12
hanger tabs mounted to each end of the unit, two "S"
hooks, and two 6" (152 mm) pieces of connecting chain.
Additional chain (P/N 05.03.020.00) can be ordered from
Hatco for the overhead mounting system or another
option can be determined by a qualified installer.
WARNING
to hold the weight of the unit securely only when
mounted properly.
chain system.
Overhead Mounting
System
"S" Hook
Connecting Chain
"S" Hook Mounting
English
Hanger Tab
Screw
Form No. GRAMM-1220