Cleaning - Proficook PC-AE 1156 Mode D'emploi

Speed Levels
Press the button repeatedly to select the desired speed
level:
Tomato, Melon
Celery, Citrus Fruits, Cucumber
Apple, Pear, Peach
Carrot, Garlic, Beet
Pomegranate, Potato
NOTE:
During operation, the speed level can not be changed.
When pressing the button the motor will switch off
automatically.
Extracting Juice
NOTE:
• The appliance is intended for short-term use. Stop the
appliance for 1 minute after operating for 3 minutes.
• You can enter a pulse mode by pressing the Pulse
button. Press the button shortly, then release it again.
WARNING:
Check all accessories again for proper attachment before
switching the appliance on.
1. Turn the appliance on by using the
display and buttons light up. The middle speed level ( )
appears in the display.
2. Select the desired speed level by pressing the
3. Start the motor by pressing the Start button.
4. Insert the fruit pieces in the filler opening and push them
down with the tamper. Please note! The tamper has a
guide way in the filler opening.
5. The juice flows out at the right side of the housing. The
pulp is collected in the pulp container. If the discharge
WARNING:
• Before cleaning always disconnect from mains power supply.
• Never immerse the motor housing in water. This can lead to
electric shock or fire.
• The centrifuge sieve is very sharp! Risk of injury!
38
PC-AE1156_IM
of juice is greatly increased, select a lower speed level.
Start the motor again by pressing the Start button. Apply
less pressure with the tamper.
NOTE:
• Observe the juice jug. Stop operation in time to prevent
overflowing.
• Berries and citrus fruits (such as gooseberries, grapes,
oranges) are usually not juiced but pressed.
• When juicing these fruits with their high juice content,
splashing of juice from the area of the pulp container
may occur. In this case, we recommend that the pulp
container is emptied more frequently.
Stop Operation and Disassembly
1. Press the Start button to switch off the motor.
2. Then switch the appliance into standby mode using the
button.
3. Disconnect from mains power supply.
4. Put the juice jug aside and open both of the closures.
5. Remove the transparent cover.
6. Remove the pulp container.
7. Remove the centrifugal sieve with the centrifuge
housing. You can do this by reaching under the flange of
the centrifugal housing and under the spout. Move the
centrifugal housing up alternately on each side. Remove
it by pulling it gradually upwards. If necessary, press
down the base appliance using the ring fingers and
small fingers.
button. The
8.
The centrifugal sieve has sharp knives!
Only lift it on its outer edge.
button.
Lift the centrifugal sieve out of the centrifuge housing.
9. Place the skimmer into the juice jug. Pay attention to the
guides in the juice jug. This prevents spilling the foam
while pouring out the juice.

Cleaning

WARNING: Risk of Cuts!
07.06.18