Husqvarna 135R Manuel D'utilisation page 15

To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
975 - 003 - 08.10.2019
To fill the fuel tank
1. Clean the area around the fuel tank cap.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
2. Shake the container and make sure that the fuel is
US fl. oz.
3. Remove the fuel tank cap and fill the fuel tank.
2 ½
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
6 ½
12 ⅞
Note: To see where the fuel tank is on your product,
refer to
To adjust the harness
1. Put on the harness.
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
4. Adjust the side straps to make the product weigh
5. Adjust the harness until the cutting attachment is
6. Let the cutting attachment lightly touch the ground.
To prepare for forestry clearing
1. Apply support to the product with the harness during
fully mixed.
refueling area and fuel source before you start the
engine.
Introduction on page 2 .
WARNING: The product must always be
correctly attached to the harness. Do not
use a defective harness.
equally on your shoulders.
parallel to the ground.
Adjust the harness clamp to balance the product
correctly.
forestry clearing.
15