On Heat Build-Up; Moisture Condensation - Sony MV-90MDV Mode D'emploi

On heat build-up

Heat may build up in the player if it is used for
an extended period of time. This, however, is
not a malfunction.

Moisture condensation

On a rainy day or in a very damp area,
moisture condensation may occur inside the
lenses. Should this occur, the player will not
operate properly. In such a case, remove the
disc and wait for about an hour until the
moisture has evaporated.
To maintain high sound quality
Be careful not to splash juice or other soft
drinks onto the player or discs.
Notes on cordless stereo
headphones
• For your safety, do not use the headphones
while driving your car.
•When the headphones are not to be used for
a long period of time, remove the batteries to
avoid damage caused by battery leakage and
subsequent corrosion.
•Do not leave the headphones in a location
subject to direct sunlight, heat or moisture (It
is recommended to use the headphones at a
temperature of between 5 ˚C and 35 ˚C).
• If the headphones are used while exposed to
direct sunlight, sensitivity of the infrared
receptor may deteriorate, and inferior quality
sound may result.
•Do not drop, hit or otherwise subject
headphones to strong shocks of any kind.
This could damage the product.
•If you leave the headphones in direct
sunlight, on a dash board etc., the batteries
may leak and burst, and cause an injury.
On installation
• Installing this unit requires technical
expertise.
This unit should be installed by a qualified
technician or service personnel.
• If you try to install this unit by yourself, do it
properly, referring to the installation and
wiring diagrams in this operating manual.
Improper installation may result in fire or
electric shock.
• Before installation, be sure to turn the
ignition switch to the OFF position or take
the key out. Installing this unit with the
ignition on may cause battery drain or a
short circuit.
• Do not damage any pipes, tubes, the fuel
tank or electric wiring when installing this
unit. This can cause a fire. If you drill a hole
in car panels, make sure that any hidden car
parts will not be damaged.
• Do not use any nuts or bolts for safety
devices such as steering linkage, fuel supply
or braking systems. This can cause a fire or
an accident.
• Take care to prevent cords and wires from
getting tangled or crimped in the moving
portion of a seat rail.
continue to next page t
5