Hendi 221082 Mode D'emploi page 8

Safety protection
• This juicer will not start unless the lid with feeding
chute has been correctly positioned and the safety
arm locked properly. The motor will be switched to
OFF as soon as you unlock the safety arm or press
the OFF button.
• This juicer is equipped with a powerful brake
Removing clogged foodstuff from lid with feeding chute
• If food is clogged, use the pusher to push it down.
If this fails to work, press the switch to the "OFF"
position and wait a while until the blade stops run-
nings.
• Dsconnect the power plug from the electrical sup-
ply outlet and remove the lid with feeding chute.
Useful Hints
Follow these helpful hints to obtain the best results from your juicer.
• Do not put any fruit or vegetables in your juicer
until power is turned ON and the motor is start
spinning.
• Allow juicer to run for a few seconds befor start
juicing.
• Do not force the food into the juicer. Allow the food
EN
to drop through slowly & steadily using the pusher.
• Any fruit or vegetables that be fit will the feeding
tube can put through whole. Cut the food if it is too
big in order to fit in the feeding tube.
• Remove large pits such as peach, mango, etc., as
this will damage the blade and possibly the juicer.
• Let the juicer run for a few seconds before turning
off to allow any excess juice to be extracted from
the pulp. Once turned OFF, wait until the juicer has
come to a complete standstill and has fully cooled
before disassembling.
• Do not recommend using overripe fruit as it will
leave too much pulp in the filter and clog the juicer.
• Do not pour liquids into the appliance at any time
Cleaning and Maintenance
• Warning! Always unplug the appliance from the
electrical power outlet before cleaning & storage.
• It is NOT recommended to wash the different parts
in dishwasher.
• Immediately after use each time, use the brush
(supplied) to thoroughly clean the fine mesh holes
of the cutting blade in the basket. Be careful of
the sharp edges! Brush the inside under running
water, holding it up towards the light to ensure the
8
which will stop the appliance in less than few sec-
onds if you unlock the safety arm while the juicer
is running.
• To switch your juicer ON again, simply lock the
safety arm properly over the lid and press the I
(ON) button.
• Wait until the juicer has come to a complete stand-
still and has fully cooled before disassembling.
• Clear all clogged foodstuff off the lid with feeding
chute.
unless you are following instructions/recipe for
making soy, rice, or nut milk.
• When using small or thin fruits or vegetables, add
many of them at the same time. For example, in-
sert 2 or 3 carrots at a time into the feeding tube
for best results.
• When juicing herbs or wheat grass, wrap them
in larger leafed vegetables such as spinach, cab-
bage, etc., and follow by a fruit or vegetavle that
contains an abundance of juice such as pineapple,
apple, etc.
• When juicing carrots that are not the same size, do
not use pusher until the largest carrot ahs been
processed. Once they have the same size, you can
use pusher to continue until carrots have been
processed.
• Denser vegetables (i.e. beets) and fibrous vegeta-
bles (i.e.celery) should be chopped and fed slowly
into the feeding tube to reduce clogging.
fine mesh holes are not blocked.
• Danger of electric shock! Do not immerse the
power cord with plug or the motor base unit in the
water or other liquids.
• Disassemble the juicer in the reverse order of as-
sembly (See → Assembly)
• Clean the motor base unit with a soft damp cloth.