Table des Matières
Publicité
1.
General instructions
WARNING
WARNING
WARNING
WARNING
• Disconnect power prior to installation
• Installation only by Qualified personnel
• Follow all applicable local and national electrical codes
• Observe ESD regulations
Care must be taken to prevent a direct electrostatic discharge
when setting the DIP switches. Regulations of the county in
which the modules are to be operated are to be observed (for
example, Germany, VDE 0100) when selecting and installing
electrical wiring.
2.
Application
Current-monitoring modules, measure DC, AC and non-sinusoidal currents
up to 60 A, and can be used for monitoring tasks in diverse areas. All vari-
ables are configured via DIP switches. Further calibration is not necessary.
The measurement circuit is galvanically isolated. Measurement results are
available for further processing as a relay contact or analog value.
3
Publicité
Table des Matières
